R3166-R3206-HP High-End Firewalls VPN Configuration Guide-6PW101

62
Figure 47 IPsec VPN policy configuration wizard: 2/4 (peer node)
2. Configure the items on the page. Table 20 describes the configuration items.
Table 20 Configuration items on a peer node: 2/4
Item Descri
p
tion
IPSec VPN Name
Type the name for the IPsec VPN.
IMPORTANT:
If you type abc here, the wizard will create an IKE peer named abc_peer, an IPsec
proposal named abc_prop, an IPsec policy named abc_poli and numbered 1,
and an IKE proposal numbered 1. The IKE peer and IPsec proposal will be
referenced in the IPsec policy.
IPSec Interface Select the interface to which you want to apply the IPsec policy.
Remote IP Address
Type the remote IP address for IKE negotiation.
IMPORTANT:
The IP address specified here must match the local IP address specified on the
peer.
Identity
Configuration
Local IP
Address
Specify the ID type of the local end for IKE negotiation phase 1, which can be
one of the following:
• Local IP address: Uses the IP address of the local gateway as the ID. If you do
not specify the IP address, the default (the primary IP address of the interface
using the security policy) is used.
• Local gateway name: Uses the name of the local gateway as the ID. As the
peer node uses the negotiation mode of main, the local end cannot use its
local gateway name for IKE negotiation. Therefore, this option is not
available.
Local
Gateway
Name
3. Click Next to enter the next page, as shown in Figure 48.