R3204P16-HP Load Balancing Module High Availability Command Reference-6PW101

49
View
DLSw, DNS, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo, UDP jitter test type view
Default level
2: System level
Parameters
None
Description
Use the route-option bypass-route command to enable the routing table bypass function to test the direct
connectivity to the direct destination.
Use the undo route-option bypass-route command to disable the routing table bypass function.
By default, the routing table bypass function is disabled.
When the routing table bypass function enabled, the routing table is not searched, and the packet is
directly sent to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Syntax
source interface interface-type interface-number
undo source interface
View
ICMP echo test type view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the source interface command to configure the source interface for ICMP echo request packets. The
ICMP echo request packets take the IP address of the source interface as their source IP address. The
specified source interface must be up; otherwise, no ICMP echo requests can be sent out.
Use the undo source interface command to restore the default.
By default, no source interface is configured for ICMP echo request packets.
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
Related commands: source ip.