R3204P16-HP Load Balancing Module High Availability Command Reference-6PW101

2
View
Any view
Default level
1: Monitor level
Parameters
verbose: Displays detailed state information of VRRP group(s).
interface interface-type interface-number: Displays VRRP group state information of the specified
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies a
VRRP group by its group number, which ranges from 1 to 255.
Description
Use the display vrrp command to display the state information of VRRP group(s).
If you do not specify verbose, only the brief state information of VRRP group is displayed.
If you specify both an interface and a VRRP group, only the state information of the specified VRRP group
on the interface is displayed; if you only specify an interface, the state information of all the VRRP groups
on the interface is displayed; if you specify neither, the state information of all the VRRP groups on the LB
module is displayed.
Examples
# When VRRP works in standard protocol mode, display brief information about all VRRP groups on the
LB module.
<Sysname> display vrrp
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface VRID State Run Adver Auth Virtual
Pri Timer Type IP
---------------------------------------------------------------------
XGE0/0.1 1 Master 140 1 Simple 1.1.1.1
# When VRRP works in standard protocol mode, display detailed information about all VRRP groups on
the LB module.
<Sysname> display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Ten-GigabitEthernet0/0.1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 150 Running Pri : 140
Preempt Mode : Yes Delay Time : 5
Auth Type : Simple Key : hello
Virtual IP : 1.1.1.1
Virtual MAC : 0000-5e00-0101