R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

54
Task Remarks
Configuring SNMP tests
Configuring TCP tests
Configuring UDP echo tests
Configuring DLSw tests
Configuring the collaboration function Optional
Configuring threshold monitoring Optional
Configuring the NQA statistics collection function Optional
Configuring the history records saving function Optional
Configuring optional parameters for an NQA test group Optional
Configuring a schedule for an NQA test group Required
Configuring the NQA server
To perform TCP, UDP echo, or UDP jitter tests, configure the NQA server on the peer device. The NQA
server responses to the probe packets sent from the NQA client by listening to the specified destination
address and port number.
Follow these steps to configure the NQA server:
To do… Use the command…
Remarks
Enter system view system-view —
Enable the NQA server nqa server enable
Required
Disabled by default.
Configure the listening
service
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The destination IP address and port number must
be the same as those configured on the NQA
client. A listening service must be unique on the
NQA server.
Enabling the NQA client
Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client:
To do… Use the command…
Remarks
Enter system view system-view —
Enable the NQA client nqa agent enable
Optional
Enabled by default.