R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

56
To do… Use the command… Remarks
Configure the source interface for
ICMP echo requests. The requests
take the IP address of the source
interface as their source IP address
when no source IP address is
specified.
source interface
interface-type
interface-number
Optional
By default, no source interface is configured
for probe packets.
The specified source interface must be up;
otherwise, no ICMP echo requests can be
sent out.
Configure the source IP address of
ICMP echo requests
source ip ip-address
Optional
By default, no source IP address is
configured.
If you configure both the source ip command
and the source interface command, the
source ip command takes effect.
The source IP address must be the IP address
of a local interface. The local interface must
be up; otherwise, no ICMP echo requests
can be sent out.
Configure the next hop IP address
of ICMP echo requests
next-hop ip-address
Optional
By default, no next hop IP address is
configured.
Configure optional parameters
See “Configuring
optional parameters for
an NQA test group”
Optional
Configuring DHCP tests
DHCP tests of an NQA test group are used to test if a DHCP server is on the network, and the time for
the DHCP server to respond to a client request and assign an IP address to the client.
Configuration prerequisites
Before you start DHCP tests, configure the DHCP server. If the NQA (DHCP client) and the DHCP server
are not in the same network segment, configure a DHCP relay.
Configuring DHCP tests
Follow these steps to configure DHCP tests:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as DHCP
and enter test type view
type dhcp Required