R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

62
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group
view
nqa entry admin-name
operation-tag
—
Configure the test type as
SNMP and enter test type
view
type snmp Required
Configure the destination
address of SNMP packets
destination ip ip-address
Required
By default, no destination IP address is configured.
Specify the source port of
SNMP packets
source port port-number
Optional
By default, no source port number is specified.
Configure the source IP
address of SNMP packets
source ip ip-address
Optional
By default, no source IP address is specified.
The source IP address must be the IP address of a
local interface. The local interface must be up;
otherwise, no probe packets can be sent out.
Configure optional
parameters
See “Configuring optional
parameters for
an NQA test
group”
Optional
Configuring TCP tests
TCP tests of an NQA test group are used to test the TCP connection between the NQA client and a port
on the NQA server and the time for setting up a connection. The test result helps you understand the
availability and performance of the services provided by the port on the server.
Configuration prerequisites
TCP tests require cooperation between the NQA server and the NQA client. Before you start TCP tests,
configure a TCP listening service on the NQA server. For more information about the TCP listening
service configuration, see “Configuring the NQA server.”
Configuring TCP tests
Follow these steps to configure TCP tests:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
TCP and enter test type
view
type tcp Required
Configure the destination
address of TCP probe
packets
destination ip ip-address
Required
By default, no destination IP address is configured.
The destination address must be the same as the IP
address of the listening service configured on the
NQA server.