R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

63
To do… Use the command… Remarks
Configure the destination
port of TCP probe packets
destination port
port-number
Required
By default, no destination port number is
configured.
The destination port number must be the same as
that of the listening service on the NQA server.
Configure the source IP
address of TCP probe
packets
source ip ip-address
Optional
By default, no source IP address is specified.
The source IP address must be the IP address of a
local interface. The local interface must be up;
otherwise, no probe packets can be sent out.
Configure optional
parameters
See “Configuring optional
parameters for an NQA
test group”
Optional
Configuring UDP echo tests
UDP echo tests of an NQA test group are used to test the connectivity and round-trip time of a UDP packet
from the client to the specified UDP port on the NQA server.
Configuration prerequisites
UDP echo tests require cooperation between the NQA server and the NQA client. Before you start UDP
echo tests, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see “Configuring the NQA server.”
Configuring UDP echo tests
Follow these steps to configure UDP echo tests:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as UDP
echo and enter test type view
type udp-echo Required
Configure the destination
address of UDP packets
destination ip ip-address
Required
By default, no destination IP address is
configured.
The destination address must be the same as the
IP address of the listening service configured on
the NQA server.
Configure the destination port of
UDP packets
destination port
port-number
Required
By default, no destination port number is
configured.
The destination port number must be the same as
that of the listening service on the NQA server.