R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

64
To do… Use the command… Remarks
Configure the size of the data
field in each UDP packet
data-size size
Optional
100 bytes by default.
Configure the string to be filled
in the data field of each UDP
packet
data-fill string
Optional
By default, the string is the hexadecimal number
00010203040506070809.
Specify the source port of UDP
packets
source port port-number
Optional
By default, no source port number is specified.
Configure the source IP address
of UDP packets
source ip ip-address
Optional
By default, no source IP address is specified.
The source IP address must be that of an
interface on the device and the interface must be
up; otherwise, no probe packets can be sent
out.
Configure optional parameters
See “Configuring
optional parameters for
an NQA test group”
Optional
Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring a DLSw test
Follow these steps to configure DLSw tests:
To do… Use the command…
Remarks
Enter system view system-view —
Enter NQA test group view nqa entry admin-name operation-tag —
Configure the test type as
DLSw and enter test type view
type dlsw Required
Configure the destination
address of probe packets
destination ip ip-address
Required
By default, no destination IP
address is configured.
Configure the source IP
address of probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Configure optional
parameters
See “Configuring optional parameters
for an NQA test group”
Optional