R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

71
Send operation times: 10 Receive response times: 10
Min/Max/Average round trip time: 2/5/3
Square-Sum of round trip time: 96
Last succeeded probe time: 2007-08-23 15:00:01.2
Extended results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of ICMP echo tests.
[LB] display nqa history admin test
NQA entry(admin admin, tag test) history record(s):
Index Response Status Time
370 3 Succeeded 2007-08-23 15:00:01.2
369 3 Succeeded 2007-08-23 15:00:01.2
368 3 Succeeded 2007-08-23 15:00:01.2
367 5 Succeeded 2007-08-23 15:00:01.2
366 3 Succeeded 2007-08-23 15:00:01.2
365 3 Succeeded 2007-08-23 15:00:01.2
364 3 Succeeded 2007-08-23 15:00:01.1
363 2 Succeeded 2007-08-23 15:00:01.1
362 3 Succeeded 2007-08-23 15:00:01.1
361 2 Succeeded 2007-08-23 15:00:01.1
DHCP test configuration example
Network requirements
As shown in Figure 35, configure NQA DHCP tests to test the time required for LB to obtain an IP address
from the DHCP server (Router).
Figure 35 Network diagram for DHCP
Configuration procedure
# Create a DHCP test group and specify interface Ten-GigabitEthernet 0/0.1 to perform NQA DHCP
tests.
<LB> system-view
[LB] nqa entry admin test
[LB-nqa-admin-test] type dhcp
[LB-nqa-admin-test-dhcp] operation interface ten-gigabitethernet 0/0.1
IP network
NQA client
Router LB
XGE0/0.1
10.1.1.1/16
Eth1/1
10.2.2.2/16
DHCP server