R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

76
# Start HTTP tests.
[LB] nqa schedule admin test start-time now lifetime forever
# Stop HTTP tests after a period of time.
[LB] undo nqa schedule admin test
# Display results of the last HTTP test.
[LB] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-11-22 10:12:47.9
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors:
Packet(s) arrived late: 0
# Display the history of HTTP tests.
[LB] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 64 Succeeded 2007-11-22 10:12:47.9
UDP jitter test configuration example
Network requirements
As shown in Figure 39, configure NQA UDP jitter tests to test the delay jitter of packet transmission
between LB and Device.
Figure 39 Network diagram for UDP jitter tests
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
1. Configure Device