R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

80
[LB-nqa-admin-test-snmp] quit
# Start SNMP tests.
[LB] nqa schedule admin test start-time now lifetime forever
# Stop the SNMP tests after a period of time.
[LB] undo nqa schedule admin test
# Display the results of the last SNMP test.
[LB] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 50/50/50
Square-Sum of round trip time: 2500
Last succeeded probe time: 2007-11-22 10:24:41.1
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of SNMP tests.
[LB] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 50 Timeout 2007-11-22 10:24:41.1
TCP test configuration example
Network requirements
As shown in Figure 41, configure NQA TCP tests to test the time for establishing a TCP connection
between LB and Device.
Figure 41 Network diagram for TCP tests
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
1. Configure Device