R3204P16-HP Load Balancing Module High Availability Configuration Guide-6PW101

Square-Sum of round trip time: 625

Last succeeded probe time: 2007-11-22 10:36:17.9

Extended results:

Packet loss in test: 0%

Failures due to timeout: 0

Failures due to disconnect: 0

Failures due to no connection: 0

Failures due to sequence error: 0

Failures due to internal error: 0

Failures due to other errors: 0

Packet(s) arrived late: 0

# Display the history of UDP echo tests.

[LB] display nqa history admin test

NQA entry (admin admin, tag test) history record(s):

Index Response Status Time

1 25 Succeeded 2007-11-22 10:36:17.9

DLSw test configuration example

Network requirements

As shown in Figure 43, configure NQA DLSw tests to test the response time of the DLSw device.

Figure 43 Network diagram for the DLSw tests

Configuration procedure

NOTE:

Before you make the configuration, make sure the devices can reach each other.

# Create a DLSw test group and configure DLSw probe packets to use 10.2.2.2 as the destination IP

address.

<LB> system-view

[LB] nqa entry admin test

[LB-nqa-admin-test] type dlsw

[LB-nqa-admin-test-dlsw] destination ip 10.2.2.2

# Enable the saving of history records.

[LB-nqa-admin-test-dlsw] history-record enable

[LB-nqa-admin-test-dlsw] quit

# Start DLSw tests.

[LB] nqa schedule admin test start-time now lifetime forever

# Stop the DLSw tests after a period of time.

[LB] undo nqa schedule admin test