R3204P16-HP Load Balancing Module Load Balancing Configuration Guide-6PW101

26
• Click Add on the Real Service tab to perform the following configuration, as shown in Figure 28.
• Type the real service name FirewallB.
• Type the IP address of the real service 10.0.1.2.
• Select the real service group FirewallGroup.
• Click Apply.
# Create virtual service VS on LB device A.
• Click Virtual Service, and click Add to perform the following configuration, as shown in Figure 29.
Figure 29 Create virtual service VS
• Type the virtual service name VS.
• Type the IP address of the virtual service 20.0.0.0.
• Select the mask 24 (255.255.255.0).
• Select the protocol type Any.
• Type the port number 0.
• Select the forwarding mode Firewall Forwarding.
• Select the real service group FirewallGroup.
• Select the Enable Virtual Service option.
• Click Apply.
Configuration verification
A period time after the hosts in the internal network access the Internet, you can display the statistics to
verify load balancing configuration on LB device A.
• Select Load Balance > Server Load Balance from the navigation tree, and click the Statistics tab.