R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

5
Field Descri
p
tion
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its link is an
on-demand link or not present at all, its protocol attribute includes the spoofing
flag (an s in parentheses). This attribute is typical of interface Null 0 and the
loopback interfaces.
Interface Interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• DOWN—The link is physically down.
• ADM—The link has been administratively shut down. To recover its physical
state, perform the undo shutdown command.
• Stby—The interface is a standby interface.
Main IP Primary IP address of the interface.
Protocol Protocol connection state of the interface, which can be UP, DOWN, or UP(s).
Duplex
Duplex mode of the interface:
• A—Auto-negotiation
• F—Full duplex
• F(a)—Auto-negotiated full duplex
• H—Half duplex
• H(a)—Auto-negotiated half duplex
PVID Port VLAN ID.
display interface
Syntax
display interface [ interface-type [ interface-number | interface-number.subnumber ] ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
interface-number.subnumber: Specifies a subinterface number, where interface-number is an interface
number; subnumber is the number of a subinterface created under the interface. The value of subnumber
ranges from 1 to 4094.
Description
Use the display interface command to display detailed information about interfaces, including their
operating status.
• If no interface type is specified, the command displays detailed information about all interfaces.
• If only interface type is specified, the command displays detailed information about all interfaces of
the particular type.