R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

6
• If both interface type and interface number are specified, the command displays detailed
information about only the specified interface.
Related commands: interface.
Examples
# Display detailed information about Layer 3 interface GigabitEthernet 0/1.
<Sysname> display interface gigabitethernet 0/1
GigabitEthernet0/1 current state: UP
Line protocol current state: UP
Description: GigabitEthernet0/1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 192.168.0.1/24 Primary
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e223-82f5
Media type is twisted pair, loopback not set, promiscuous mode not set
100Mb/s, Full-duplex, link type is autonegotiation
Output flow-control is disabled, input flow-control is disabled
Last clearing of counters: 17:14:08 Tue 05/09/2010
Last 300 seconds input rate 3 bytes/sec, 24 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 1018 packets, 0 jumboes, 156202 bytes, 1018 buffers
23 broadcasts, 0 multicasts, 0 pauses
0 errors, 0 runts, 0 giants
0 crc, 0 align errors, 0 overruns
0 dribbles, 0 drops, 0 no buffers
Output:826 packets, 242335 bytes, 826 buffers
2 broadcasts, 0 multicasts, 0 pauses
0 errors, 0 underruns, 0 collisions
0 deferred, 0 lost carriers
Table 2 display interface command (in route mode) output description
Field Descri
p
tion
GigabitEthernet0/1 current
state
Physical layer state of the Ethernet interface.
Line protocol current state Link layer state of the Ethernet interface.
Hold timer is Hold timer of the link state.
Internet Address is
The IP address of the interface.
When no IP address is configured, this field displays IP packet processing,
and disabled indicates that IP packets cannot be processed.
Last 300 seconds input rate Average input rate over the last 300 seconds in Bps, bps, and pps.
Last 300 seconds output rate Average output rate over the last 300 seconds in Bps, bps, and pps.
Input Input packets.
Output Output packets.
# Display detailed information about Layer 2 Ethernet interface GigabitEthernet 0/2.
<Sysname> display interface gigabitethernet 0/2
GigabitEthernet0/2 current state: DOWN