R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

106
Field Descri
p
tion
Total Total number
display router id
Syntax
display router id
View
Any view
Default level
1: Monitor level
Parameters
None
Description
Use the display router id command to display the router ID.
Examples
# Display the router ID.
<Sysname> display router id
Configured router ID is 1.1.1.1
router id
Syntax
router id router-id
undo router id
View
System view
Default level
2: System level
Parameters
router-id: Router ID, expressed as an IPv4 address.
Description
Use the router id command to configure a router ID.
Use the undo router id command to remove the router ID.
By default, no router ID is configured.
Some routing protocols use a router ID to identify a routing device. A route ID is selected in the following
sequence:
• Select the router ID configured with the router id command.
• Select the highest loopback interface IP address as the router ID.