R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

107

• If no loopback interface IP address is available, the highest physical interface IP address is selected

as the router ID (regardless of the interface state).

• If the interface whose IP address is the router ID is removed or modified, a new router ID is selected.

Other events, (the interface goes down; after a physical interface’s IP address is selected as the

router ID, an IP address is configured for a loopback interface; a higher interface IP address is

configured) will not trigger a router ID re-selection.

• After a router ID is changed, use the reset command to make it effective.

Examples

# Configure a router ID.

<Sysname> system-view

[Sysname] router id 1.1.1.1

reset ip routing-table statistics protocol

Syntax

reset ip routing-table statistics protocol { protocol | all }

View

User view

Default level

2: System level

Parameters

protocol: Clears statistics for the IPv4 routing protocol, which can be bgp, direct, ospf, rip, or static.

all: Clears statistics for all IPv4 routing protocols.

Description

Use the reset ip routing-table statistics protocol command to clear routing statistics for the routing table.

Static routing configuration commands

delete static-routes all