R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

10
Field Descri
p
tion
late collisions
Number of frames that the interface deferred to transmit after
transmitting their first 512 bits, because of detected collisions.
lost carrier
Number of carrier losses during transmission. This counter applies to
serial WAN interfaces.
- no carrier
Number of times that the port failed to detect the carrier when
attempting to send frames. This counter applies to serial WAN
interfaces.
NOTE:
If an output field is not available, a hyphen (-) is displayed.
# Display information about Layer 2 Ethernet subinterface GigabitEthernet 0/2.1.
<Sysname> display interface gigabitethernet 0/2.1
GigabitEthernet0/2.1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e265-325b
Description: GigabitEthernet0/2.1 Interface
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
PVID: 1
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 4 display interface command (in Layer 2 subinterface mode) output description
Field Descri
p
tion
GigabitEthernet0/2.1 current state Current state of the Ethernet subinterface.
IP Packet Frame Type Frame type of the Ethernet subinterface.
Broadcast MAX-ratio Broadcast storm suppression ratio.
Unicast MAX-ratio Unknown storm suppression ratio.
Multicast MAX-ratio Multicast storm suppression ratio.
PVID Port VLAN ID.
Tagged VLAN ID
VLANs for which the interface sends packets without removing VLAN
tags.
Untagged VLAN ID
VLANs for which the interface sends packets after removing VLAN
tags.
0 packets input, 0 bytes, 0 drops Statistics on the packets received.
0 packets output, 0 bytes, 0 drops Statistics on the packets sent.