R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

11
duplex
Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet interface view
Default level
2: System level
Parameters
auto: Sets the interface to operate in auto-negotiation mode.
full: Sets the interface to operate in full-duplex mode.
half: Sets the interface to operate in half-duplex mode. This keyword is not available for the fiber combo
ports and 10-GE interfaces.
Description
Use the duplex command to set the duplex mode for an Ethernet interface.
Use the undo duplex command to restore the default duplex mode of the Ethernet interface.
By default, a 10-GE interface operates in full-duplex mode, and all other types of Ethernet interfaces
operate in auto-negotiation mode.
Related commands: speed.
Examples
# Configure interface GigabitEthernet 0/3 to operate in full-duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/3
[Sysname-GigabitEthernet0/3] duplex full
flow-control
Syntax
flow-control
undo flow-control
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use the flow-control command to enable flow control on an Ethernet interface.