R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

17
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use the sub-interface rate-statistic command to enable rate statistics collection for the subinterfaces of an
Ethernet interface.
Use the undo sub-interface rate-statistic command to disable rate statistics collection for the
subinterfaces of an Ethernet interface.
By default, the system does not collect rate statistics for Ethernet subinterfaces.
Examples
# Enable rate statistics collection on the subinterfaces of Ten-GigabitEthernet 0/0.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 0/0
[Sysname-Ten-GigabitEthernet0/0] sub-interface rate-statistic
Layer 2 Ethernet interface and subinterface
configuration commands
broadcast-suppression
Syntax
broadcast-suppression ratio
undo broadcast-suppression
View
Layer 2 Ethernet interface view, Layer 2 Ethernet subinterface view
Default level
2: System level
Parameters
ratio: Sets the broadcast suppression threshold as a percentage of the transmission capability of an
Ethernet interface. The smaller the percentage, the less broadcast traffic is allowed to pass through.
• For LB modules that support linear suppression mode, this argument ranges from 1 to 100.
• For LB modules that do not support linear suppression mode, this argument ranges from 5 to 100.
Description
Use the broadcast-suppression command to set the broadcast suppression threshold on an Ethernet
interface or subinterface.
Use the undo broadcast-suppression command to restore the default.