R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

19
multicast-suppression
Syntax
multicast-suppression ratio
undo multicast-suppression
View
Layer 2 Ethernet interface view, Layer 2 Ethernet subinterface view
Default level
2: System level
Parameters
ratio: Sets the multicast suppression threshold as a percentage of the transmission capability of an
Ethernet interface, in the range 1 to 100. The smaller the percentage, the less multicast traffic is allowed
to pass through.
Description
Use the multicast-suppression command to set the multicast suppression threshold on an Ethernet
interface or subinterface.
Use the undo multicast-suppression command to restore the default.
By default, Ethernet interfaces do not suppress multicast traffic.
When multicast traffic exceeds the threshold you configure, the system discards multicast packets until the
multicast traffic drops below the threshold.
Examples
# Set the multicast threshold to 20% on Ethernet interface Ten-GigabitEthernet 0/0.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 0/0
[Sysname-Ten-GigabitEthernet0/0] multicast-suppression 20
# Set the multicast threshold to 20% on Ethernet subinterface Ten-GigabitEthernet 0/0.1.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 0/0.1
[Sysname-Ten-GigabitEthernet0/0.1] multicast-suppression 20
unicast-suppression
Syntax
unicast-suppression ratio
undo unicast-suppression
View
Layer 2 Ethernet interface view, Layer 2 Ethernet subinterface view
Default level
2: System level