R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

22
[Sysname] interface Ten-GigabitEthernet 0/0
[Sysname-Ten-GigabitEthernet0/0] timer hold 20
Loopback and null interface configuration
commands
description
Syntax
description text
undo description
View
Loopback interface view, Null 0 interface view
Default level
2: System level
Parameters
text: Specifies the interface description, a string of 1 to 80 characters. The string can include
case-sensitive letters, digits, special characters (including ~ ! @ # $ % ^ & * ( ) - _ + = { } [ ] | \ : ; " '
< > , . /), spaces, and other Unicode characters and symbols.
NOTE:
• Each Unicode character takes the space of two regular characters.
• To use Unicode characters or symbols in an interface description, install the specific input method editor
and log in to the device through remote login software that supports this character type.
• When the length of a description string reaches or exceeds the maximum line width on the terminal
software, the software starts a new line, possibly breaking a Unicode character into two and creatin
g
garbled characters at the end of a line.
Description
Use the description command to set a description for the interface.
Use the undo description command to restore the default.
By default, the description of a loopback or null interface is the interface name plus interface, loopback1
interface for example.
Related commands: display interface.
Examples
# Configure the description of interface loopback 1 as loopback1.
<Sysname> system-view
[Sysname] interface loopback 1
[Sysname-LoopBack1] description loopback1