R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

24
Field Descri
p
tion
Last clearing of counters
The time when the reset counts interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device’s startup.
Last 300 seconds input: 0 bytes/sec,
0 bits/sec, 0 packets/sec
Average input rate over the last 300 seconds:
• Packets/sec—The average number of packets received per
second.
• Bytes/sec—The average number of bytes received per second.
• Bits/sec —The average number of bits received per second.
Last 300 seconds output: 0 bytes/sec,
0 bits/sec, 0 packets/sec
Average output rate over the last 300 seconds:
• Packets/sec—The average number of packets sent per second.
• Bytes/sec—The average number of bytes sent per second.
• Bits/sec—The average number of bits sent per second.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the input packets of the interface
and the number of the dropped packets.
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the output packets of the interface
and the number of the dropped packets.
display interface null
Syntax
display interface null [ 0 ]
View
Any view
Default level
1: Monitor level
Parameters
0: Specifies interface Null 0. The null interface number is fixed to 0.
Description
Use the display interface null command to display information about the null interface. Null 0 is the only
null interface on a device, and this command displays information about interface Null 0 even if you do
not specify the 0 keyword.
Related commands: interface null.
Examples
# Display information about interface Null 0.
<Sysname> display interface null 0
NULL0 current state :UP
Line protocol current state :UP (spoofing)
Description : NULL0 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
Physical is NULL DEV