R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

35
<Sysname> display mac-address aging-time
Mac address aging time: 300s
The output indicates that the aging time of dynamic entries in the MAC address table is 300 seconds.
mac-address (interface view)
Syntax
mac-address { dynamic | static } mac-address vlan vlan-id
undo mac-address { dynamic | static } mac-address vlan vlan-id
View
Ethernet interface view
Default level
2: System level
Parameters
dynamic: Dynamic MAC address entries. These entries can age.
static: Static MAC address entries. They do not age, but you can add or remove them.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, inputting “f-e2-1” indicates that the MAC
address is “000f-00e2-0001”.
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, in the range 1 to 4094.
Description
Use the mac-address command to add or modify a MAC address entry on a specified interface.
Use the undo mac-address command to remove a MAC address entry on the interface.
The MAC address entries configuration cannot survive a reboot unless you save it. The dynamic MAC
address table entries, however, are lost at next reboot whether or not you save the configuration.
Related commands: display mac-address.
Examples
# Add a static entry for MAC address 000f-e201-0101 on port GigabitEthernet 0/2 that belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/2
[Sysname-GigabitEthernet0/0] mac-address static 000f-e201-0101 vlan 2
mac-address (system view)
Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]