R3204P16-HP Load Balancing Module Network Management Command Reference-6PW101

54
port hybrid pvid vlan
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
View
Ethernet interface view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, ranging from 1 to 4094.
Description
Use the port hybrid pvid vlan command to configure the PVID of the hybrid port.
Use the undo port hybrid pvid command to restore the default.
By default, the PVID of a hybrid port is VLAN 1.
You can use a nonexistent VLAN as the PVID for a hybrid port. If you remove the PVID of a hybrid port
with the undo vlan command, it does not affect the setting of the PVID on the port.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to allow and forward packets
from the PVID.
Related commands: port link-type and port hybrid vlan.
Examples
# Configure VLAN 100 as the PVID of the hybrid port Ten-GigabitEthernet 0/0.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface Ten-GigabitEthernet 0/0
[Sysname-Ten-GigabitEthernet0/0] port link-type hybrid
[Sysname-Ten-GigabitEthernet0/0] port hybrid pvid vlan 100
port hybrid vlan
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
View
Ethernet interface view
Default level
2: System level