R3204P16-HP Load Balancing Module Network Management Configuration Guide-6PW101
Table Of Contents
- Title page
- Contents
- Interface management configuration
- IP addressing configuration
- MAC address table configuration
- Layer 2 forwarding configuration
- Layer 2 forwarding overview
- Configuring general Layer 2 forwarding
- Configuring inline Layer 2 forwarding
- Configuring inter-VLAN Layer 2 forwarding
- Forward-type inline Layer 2 forwarding configuration example
- Blackhole-type inline Layer 2 forwarding configuration example
- Inter-VLAN Layer 2 forwarding configuration example
- VLAN configuration
- ARP configuration
- Gratuitous ARP configuration
- Proxy ARP configuration
- Layer 3 forwarding configuration
- NAT configuration
- Overview
- Configuring a NAT policy in the web interface
- Configuring NAT in the CLIs
- Configuration guidelines
- ALG configuration
- Static route configuration
- RIP configuration
- OSPF configuration
- BGP configuration
- Policy-based routing configuration
- Route displaying
- DNS configuration
- Overview
- Configuring DNS on the web interface
- Configuring DNS in the CLIs
- Troubleshooting IPv4 DNS configuration
- Support and other resources
- Index
122
2. Enable RIP.
# Configure LB A.
• Select Network > RIP from the navigation tree of LB A.
• Select the Enable RIP(Enable all interfaces automatically) check box, as shown in Figure 78.
• Cl
ick Apply.
Figure 78 Enable RIP
# Configure LB B.
• Select Network > RIP from the navigation tree of LB B.
• Select the Enable RIP(Enable all interfaces automatically) check box, as shown in Figure 78.
• Cl
ick Apply.
Configuration verification
# Display active routes of LB A.
Select Network > Routing Info from the navigation tree of LB A to display learned RIP route destined for
10.0.0.0/8, as shown in Figure 79.
Figure 79 RIP configuration result I
# Display active routes of LB B.
Select Network > Routing Info from the navigation tree of LB B to display learned RIP routes destined for
2.0.0.0/8 and 3.0.0.0/8, as shown in Figure 80.
Ten -GigatibEthernet 0/0.2
Ten -GigatibEthernet 0/0 .1
Ten -GigatibEthernet 0/0 .3
Ten -GigatibEthernet 0/0 .1
Destination Mask Protocol Priority Next Hop Interface