R3204P16-HP Load Balancing Module Network Management Configuration Guide-6PW101

135
# Configure Device C.
• Select Network > OSPF from the navigation tree of Device C.
• Select the Enable OSPF check box.
• Select the Import static routes check box.
• Click Apply.
• Click Add on the Area Configuration tab.
• Type 1 for Area ID.
• Select NSSA for Area Type.
• Type 10.2.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click Add
Network.
• Type 10.4.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click Add
Network.
• Click Apply.
• Select Network > Static Route from the navigation tree and click Add.
• Type 3.2.1.1 as the destination IP address.
• Select 255.255.255.0 from the mask drop-down list.
• Type 10.4.1.2 as the nexthop.
• Cl
ick Apply.
# Configure Device D.
• Select Network > OSPF from the navigation tree of Device D.
• Select the Enable OSPF check box.
• Click Apply.
• Click Add on the Area Configuration tab.
• Type 2 for Area ID.
• Select Normal for Area Type.
• Type 10.3.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click Add
Network.
• Type 10.5.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click Add
Network.
• Click Apply.
Configuration verification
# Display neighbor information of Device A.
Select Network > OSPF from the navigation tree of Device A, and then click Show Peer in the Show
Information field. A neighbor in Full state is displayed in area 0 and area 1, respectively, as shown
in Figure 93. (
192.168.1.42 is the router ID of Device B, and 192.168.1.57 is the router ID of Device C.)
Figure 93 OSPF configuration result I