R3204P16-HP Load Balancing Module Security Command Reference-6PW101

82
[Sysname-luser-111] group abc
idle-cut enable
Syntax
idle-cut enable minute flow
undo idle-cut enable
View
ISP domain view
Default level
2: System level
Parameters
minute: Maximum idle duration allowed, in the range 1 to 600 minutes.
flow: User idle threshold, in the range 1 to 10240000 bytes.
Description
Use the idle-cut enable command to enable the idle cut function and set the relevant parameters. With
the idle cut function enabled for a domain, the system will log out any user in the domain whose traffic
is less than the specified user idle threshold during the maximum idle duration.
Use the undo idle-cut command to restore the default.
By default, the function is disabled.
You can also set the maximum idle duration parameter on the server. In this case, if you enable the idle
cut function and set the relevant parameters on the LB module, the settings on the LB module will take
effect; if you disable the function on the LB module, the setting of the maximum idle duration parameter
on the server will take effect.
The user idle threshold parameter can only be set on the LB module. The server always assigns a user idle
threshold of 10240 bytes to a user. If you set the parameter on the LB module, the card uses your setting;
otherwise, the card uses that assigned by the server.
Related commands: domain.
Examples
# Enable the idle cut function and set the idle duration threshold to 50 minutes and the traffic threshold
to 1024 bytes for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] idle-cut enable 50 1024
local-user
Syntax
local-user user-name
undo local-user { user-name | all | service-type { ftp | ssh | telnet | terminal } }
View
System view