R3204P16-HP Load Balancing Module Security Configuration Guide-6PW101

157
Figure 117 Add an account for device management
2. Configure the LB module
# Configure the IP address of interface Ten-GigabitEthernet 0/0.1, through which the Telnet user accesses
the card.
<LB> system-view
[LB] interface Ten-GigabitEthernet 0/0.1
[LB-Ten-GigabitEthernet0/0.1] ip address 192.168.1.70 255.255.255.0
[LB-Ten-GigabitEthernet0/0.1] quit
# Configure the IP address of interface Ten-GigabitEthernet 0/0.2, through which the card
communicates with the server.
[LB] interface Ten-GigabitEthernet 0/0.2
[LB-Ten-GigabitEthernet0/0.2] ip address 10.1.1.2 255.255.255.0
[LB-Ten-GigabitEthernet0/0.2] quit
# Enable the Telnet server on the card.
[LB] telnet server enable
# Configure the card to use AAA for Telnet users.
[LB] user-interface vty 0 4
[LB-ui-vty0-4] authentication-mode scheme
[LB-ui-vty0-4] quit
# Create RADIUS scheme rad.
[LB] radius scheme rad
# Specify the primary authentication server.