R3204P16-HP Load Balancing Module Security Configuration Guide-6PW101

11
• Select Security > NAT from the navigation tree, and in the right pane select the Static NAT tab. Then
click Add in the Static Address Mapping area to enter the page shown in Figure 11.
Figure 11 Add a static a
ddress mapping
• Ty p e 1.1.1.1 fo r Internal IP Address.
• Type 2.2.2.3 for Global IP Address.
• Click Apply.
# Enable static NAT on Ten-GigabitEthernet 0/0.2.
• In the Interface Static Translation area of the Static NAT tab, click Add to enter the page shown
in Figure 12.
Figure 12 Enable static NAT on an interface
• Select interface Ten-GigabitEthernet 0/0.2.
• Click Apply.
# Configure virtual fragment reassembly.
• Select Security > Virtual Reassembly from the navigation tree to enter the page shown in Figure 13.