R3204P16-HP Load Balancing Module Security Configuration Guide-6PW101

192
RSH configuration example
Network requirements
As shown in Figure 127, the LB module acts as the RSH client. The remote host runs Windows 2000 and
has had RSH daemon service started. The requirement is to set the time of the host remotely from the LB
module.
NOTE:
W
indows NT, 2000, XP, and 2003 are shipped with no RSH daemon. Therefore, the RSH daemon mus
t
be obtained and installed separately on the remote host.
Figure 127 Network diagram for RSH configuration
Configuration procedure
1. Configure the remote host
# On the remote host, check that the RSH daemon has been installed and started properly by following
these steps:
• From the Windows control panel, open the Administrative Tools folder. (For Windows XP, if you use
the category view of the Control Panel window, select Administrative Tools from Performance and
Maintenance.)
Figure 128 Administrative Tools folder
• Double-click the Services icon to display the Services window.
Internet
LB
Windows 2000 host
192.168.1.10/24