R3204P16-HP Load Balancing Module Security Configuration Guide-6PW101

31
Figure 32 Network diagram for traffic abnormality detection configuration
Configuration procedure
# Assign IP addresses to interfaces. (Omitted)
# Enable the blacklist feature.
Select Security > Intrusion Detection from the navigation tree and then select the Blacklist tab and
perform the configuration shown in Figure 33.
Figure 33 Enable the blacklist feature
• In the Global Configuration area, select the Enable Blacklist option.
• Click Apply.
# Configure scanning detection for the untrusted zone.
Select Security > Intrusion Detection from the navigation tree and then select the Scanning Detection tab
to enter the scanning detection configuration page and perform configurations shown in Figure 34.
Figure 34 Configure scanning detection for the untrusted zone