R3204P16-HP Load Balancing Module System Maintenance Command Reference-6PW101

24
<188>Jul 22 05:58:06 2008 Sysname %%10IFNET/4/LINK UPDOWN(l): Ten-GigabitEthernet0/0.2:
link status is UP
# Specify the primary IP address of interface Ten-GigabitEthernet 0/0.1 as the source IP address of log
information.
<Sysname> system-view
[Sysname] interface Ten-Gigabitethernet0/0.1
[Sysname-Ten-Gigabitethernet0/0.1] ip address 2.2.2.2 24
[Sysname-Ten-Gigabitethernet0/0.1] quit
[Sysname] info-center loghost source Ten-GigabitEthernet0/0.1
After the above configuration, the log information in the following format is displayed on the log host
(compared with the default format, the following format has the -DevIP=2.2.2.2 field):
<188>Jul 22 06:11:31 2008 Sysname %%10IFNET/4/LINK UPDOWN(l):-DevIP=2.2.2.2;
Ten-GigabitEthernet0/0.1: link status is UP
info-center monitor channel
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
View
System view
Default level
2: System level
Parameters
channel-number: Specifies a channel number, which ranges from 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, see the info-center channel name command.
Description
Use the info-center monitor channel command to configure the channel to output system information to
the monitor.
Use the undo info-center monitor channel command to restore the default channel to output system
information to the monitor.
By default, output of system information to the monitor is enabled with a default channel name of monitor
and a default channel number of 1.
NOTE:
The info-center monitor channel command takes effect only after the information center is enabled with
the info-center enable command.
Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0