R3204P16-HP Load Balancing Module System Maintenance Command Reference-6PW101

34
Use the undo terminal debugging command to disable the display of debugging information on the
current terminal.
By default, the display of debugging information on the current terminal is disabled.
Note that:
• To display the debugging information, you need to execute the terminal monitor and terminal
debugging commands, then enable information center (enabled by default), and finally use a
debugging command to enable the related debugging.
• The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of debugging information on the terminal
restores the default.
Examples
# Enable the display of debugging information on the current terminal.
<Sysname> terminal debugging
Info: Current terminal debugging is on.
terminal logging
Syntax
terminal logging
undo terminal logging
View
User view
Default level
1: Monitor level
Parameters
None
Description
Use the terminal logging command to enable the display of log information on the current terminal.
Use the undo terminal logging command to disable the display of log information on the current
terminal.
By default, the display of log information on the current terminal is enabled.
Note that:
• To display the log information, you need to execute the terminal monitor and terminal logging
commands, and then enable information center (enabled by default).
• The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of log information on the terminal restores
the default.
Examples
# Disable the display of log information on the current terminal.
<Sysname> undo terminal logging
Info: Current terminal logging is off.