R3204P16-HP Load Balancing Module System Maintenance Command Reference-6PW101

36
Parameters
None
Description
Use the terminal trapping command to enable the display of trap information on the current terminal.
Use the undo terminal trapping command to disable the display of trap information on the current
terminal.
By default, the display of trap information on the current terminal is enabled.
Note that:
• To display the trap information, you need to execute the terminal monitor and terminal trapping
commands, and then enable information center (enabled by default).
• The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of trap information on the terminal
restores the default.
Examples
# Enable the display of trap information on the current terminal.
<Sysname> terminal trapping
Info: Current terminal trapping is on.