R3204P16-HP Load Balancing Module System Maintenance Command Reference-6PW101

61
View
System view
Default level
3: Manage level
Parameters
trap: Specifies the host to be the target host which receives traps and notifications from the device.
address: Specifies the destination IP address in the SNMP messages sent from the device.
udp-domain: Indicates that the trap is transmitted using UDP.
ip-address: The IPv4 address of the trap target host.
udp-port port-number: Specifies the number of the port on the target host to receive traps. The value
defaults to 162.
params securityname security-string: Specifies the authentication related parameter, which is an
SNMPv1 or SNMPv2c community name or an SNMPv3 user name, a string of 1 to 32 characters.
v1: SNMPv1. This keyword must be the same as the SNMP version on the NMS; otherwise, the NMS
cannot receive any trap.
v2c: SNMPv2c. This keyword must be the same as the SNMP version on the NMS; otherwise, the NMS
cannot receive any trap.
v3: SNMPv3. This keyword must be the same as the SNMP version on the NMS; otherwise, the NMS
cannot receive any trap.
• authentication: Specifies the security model to be authentication without privacy. Authentication is
a process to check whether the packet is integral and whether it has been tampered. When
creating an SNMPv3 user, configure the authentication password.
• privacy: Specifies the security model to be authentication with privacy. Privacy is to encrypt the data
part of a packet to prevent it from being intercepted. When creating an SNMPv3 user, configure the
authentication password and privacy password.
Description
Use the snmp-agent target-host command to configure the related settings for a trap target host.
Use the undo snmp-agent target-host command to remove the current settings. According to the
networking requirements, you can use this command for multiple times to configure different settings for
a target host, enabling the device to send trap messages to different NMSs.
• If udp-port port-number is not specified, port number 162 is used.
• If the key words v1, v2 and v3 are not specified, v1 is used.
• If the key words authentication and privacy are not specified, the authentication mode is no
authentication, no privacy.
Related commands: enable snmp trap updown, snmp-agent trap enable, snmp-agent trap life, and
snmp-agent trap source.
Examples
# Enable the device to send SNMPv1 traps to 10.1.1.1, using the community name of public.
<Sysname> system-view
[Sysname] snmp-agent trap enable standard
[Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname
public