R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

5
Tracert configuration
Follow the step below to configure tracert:
To do… Use the command…
Remarks
Display the routes
from source to
destination
tracert [ -a source-ip | -f first-ttl
| -m max-ttl | -p port | -q
packet-number | -w timeout ]
* host
Required
Use either approach
The tracert command is applicable in an IPv4 network.
Available in any view
System debugging
Introduction to system debugging
The device provides various debugging functions. For the majority of protocols and features supported,
the system provides debugging information to help users diagnose errors.
The following two switches control the display of debugging information:
• Protocol debugging switch: Controls protocol-specific debugging information.
• Screen output switch: Controls whether to display the debugging information on a certain screen.
As Figure 3 illu
strates, assume the device can provide debugging for the three modules 1, 2, and 3. The
debugging information can be output on a terminal only when both the protocol debugging switch and
the screen output switch are turned on.
Figure 3 The relationship between the protocol and screen output switch
Configuring system debugging
Administrators usually use the debugging commands to diagnose network failure. However, output of the
debugging information may reduce system efficiency. Therefore, when debugging is completed, disable