R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

16
To do… Use the command… Remarks
Enable the monitoring of system
information on the console
terminal monitor
Optional
Enabled on the console and disabled on
the monitor terminal by default.
Enable the display of debugging
information on the console
terminal debugging
Required
Disabled by default
Enable the display of log
information on the console
terminal logging
Optional
Enabled by default
Enable the display of trap
information on the console
terminal trapping
Optional
Enabled by default
Outputting system information to a monitor terminal
System information can also be output to a monitor terminal, which is a user terminal that has login
connections through the AUX or VTY user interface.
Outputting system information to a monitor terminal
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel channel-number
name channel-name
Optional
See Table 2 for default channel names.
Configure the channel
through which system
information can be output to a
monitor terminal
info-center monitor channel
{ channel-number | channel-name }
Optional
By default, system information is output
to the monitor terminal through channel
1 (known as monitor).
Configure the output rules of
the system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional
See “Default output rules of system
informa
tion.”
Configure the format of the
time stamp
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
By default, the time stamp format for
log, trap and debugging information is
date.
Enabling the display of system information on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the associated
display function in order to display the output information on the monitor terminal.
Follow these steps to enable the display of system information on a monitor terminal: