R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

17
To do… Use the command… Remarks
Enable the monitoring of system
information on a monitor terminal
terminal monitor
Required
Enabled on the console and disabled on the
monitor terminal by default.
Enable the display of debugging
information on a monitor terminal
terminal debugging
Required
Disabled by default
Enable the display of log
information on a monitor terminal
terminal logging
Optional
Enabled by default
Enable the display of trap
information on a monitor terminal
terminal trapping
Optional
Enabled by default
Outputting system information to a log host
To do… Use the command… Remarks
Enter system view system-view —
Enable information
center
info-center enable
Optional
Enabled by default
Name the channel with
a specified channel
number
info-center channel channel-number
name channel-name
Optional
See Table 2 for default channel names.
Configure the output
rules of the system
information
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level severity
| state state } * | log { level severity |
state state } * | trap { level severity |
state state } * ] *
Optional
See “Default output rules of system
informa
tion.”
Specify the source IP
address for the log
information
info-center loghost source
interface-type interface-number
Optional
By default, the source interface is
determined by the matched route, and the
primary IP address of this interface is the
source IP address of the log information.
Configure the format of
the time stamp for
system information
output to the log host
info-center timestamp loghost { date |
iso | no-year-date | none }
Optional
date by default.
Set the format of the
system information sent
to a log host to
UNICOM
info-center format unicom
Optional
HP by default.