R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

18
To do… Use the command… Remarks
Specify a log host and
configure the related
output parameters
info-center loghost host-ipv4-address
[ port port-number ] [ channel
{ channel-number | channel-name } |
facility local-number ] *
Required
By default, the system does not output
information to a log host. If you specify to
output system information to a log host,
the system uses channel 2 (loghost) by
default.
The value of the port-number argument
should be the same as the value
configured on the log host, otherwise, the
log host cannot receive system
information.
Outputting system information to the trap buffer
NOTE:
The trap buffer receives the trap information only, and discards the lo
g
and debu
gg
in
g
information even
if you have configured to output them to the trap buffer.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel channel-number
name channel-name
Optional
See Table 2 for default channel
names.
Configure the channel
through which system
information can be output to
the trap buffer and specify the
buffer size
info-center trapbuffer [ channel
{ channel-number | channel-name } |
size buffersize ] *
Optional
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
Configure the output rules of
the system information
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level severity |
state state } * | log { level severity |
state state } * | trap { level severity |
state state } * ] *
Optional
See “Default output rules of system
informati
on.”
Configure the format of the
time stamp
info-center timestamp { debugging | log
| trap } { boot | date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.