R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

19
Outputting system information to the log buffer
NOTE:
You can configure to output log, trap, and debugging information to the log buffer, but the log buffer
receives the log and debugging information only, and discards the trap information.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a
specified channel number
info-center channel channel-number
name channel-name
Optional
See Table 2 for default channel names.
Configure the channel
through which system
information can be output to
the log buffer and specify the
buffer size
info-center logbuffer [ channel
{ channel-number | channel-name }
| size buffersize ] *
Optional
By default, system information is output
to the log buffer through channel 4
(known as logbuffer) and the default
buffer size is 512.
Configure the output rules of
the system information
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional
See “Default output rules of system
informa
tion.”
Configure the format of the
time stamp
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional
The time stamp format for log, trap and
debugging information is date by
default.
Outputting system information to the SNMP module
NOTE:
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For more information, see the
chapter “SNMP configuration.”
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command…
Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default