R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

72
# Specify newest.bin as the main boot file to be used at the next startup.
<Sysname> boot-loader file newest.bin main
# Reboot LB module, and the boot file is updated at the system reboot.
<Sysname> reboot
CAUTION:
The boot file used at the next startup must be saved under the root directory of the storage medium (For a
device that has been partitioned, the boot file must be saved on the first partition). You can copy or move
a file to the root directory of the storage medium. For more information about the boot-loader command,
see
System Management Command Reference .
Configuring the FTP server
Configuring FTP server operating parameters
The FTP server uses one of the two modes to update a file when you upload the file (use the put command)
to the FTP server:
• In fast mode, the FTP server starts writing data to the storage medium after a file is transferred to the
memory. This prevents the existing file on the FTP server from being corrupted in the event that
anomaly, power failure for example, occurs during a file transfer.
• In normal mode, the FTP server writes data to the storage medium while receiving data. This means
that any anomaly, power failure for example, during file transfer might result in file corruption on the
FTP server. This mode, however, consumes less memory space than the fast mode.
Follow these steps to configure the FTP server:
To do… Use the command…
Remarks
Enter system view system-view —
Enable the FTP server
ftp server enable
Required
Disabled by default.
Use an ACL to control FTP clients’
access to the FTP server
ftp server acl acl-number
Optional
By default, no ACL is used to control FTP
clients’ access to the FTP server.
Configure the idle-timeout timer ftp timeout minutes
Optional
30 minutes by default.
Within the idle-timeout time, if there is no
information interaction between the FTP
server and client, the connection between
them is terminated.
Set the file update mode for the FTP
server
ftp update { fast |
normal }
Optional
Normal update is used by default.
Quit to user view quit —
Manually release the FTP
connection established with the
specified username
free ftp user username
Optional
Available in user view