R3204P16-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

78
To do… Use the command… Remarks
Specify the source IP address
of sent TFTP packets
tftp client source { interface interface-type
interface-number | ip source-ip-address }
Optional
By default, the source IP address
is determined by the route from
the TFTP client to the TFTP server.
Return to user view quit —
Download or upload a file in
an IPv4 network
tftp server-address { get | put | sget }
source-filename [ destination-filename ]
[ source { interface interface-type
interface-number | ip source-ip-address } ]
Optional
Available in user view
NOTE:
• If no primary IP address is configured on the source interface, no TFTP connection can be established.
• If you use the tftp client source command to configure a source interface and then use it to configure a
source IP address, the source IP address overwrites the source interface, and vice versa.
Displaying and maintaining the TFTP client
To do… Use the command… Remarks
Display the source IP address configuration
of the TFTP client
display tftp client configuration Available in any view
TFTP client configuration example
Network requirements
• As shown in Figure 32, use a PC as the TFTP server and LB module as the TFTP client. Their IP
addresses are 1.2.1.1/16 and 1.1.1.1/16 respectively. LB module and PC are reachable to each
other.
• LB module downloads a boot file from PC for upgrading and uploads a configuration file named
config.cfg to PC for backup.
Figure 32 Smooth upgrading using the TFTP client function
Configuration procedure
1. Configure the PC (TFTP server), the configuration procedure is omitted.
• On the PC, enable the TFTP server
• Configure a TFTP working directory
2. Configure LB module (TFTP client)