R3204P16-HP Load Balancing Module System Management Command Reference-6PW101

110
View
Any view
Default level
1: Monitor level
Parameters
by-linenum: Displays the number of each line.
Description
Use the display this command to display the valid configuration information under the current view.
To check whether your configuration takes effect, use the display this command.
The valid configuration that is the same as the default is not displayed.
The invalid configuration is not displayed.
Execution of this command in any user interface view displays the valid configuration in all the user
interfaces.
Execution of this command in any VLAN view displays the configurations of all the created VLANs.
Examples
# Display the valid configuration information on interface GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] display this
#
interface GigabitEthernet0/1
port link-mode route
ip address 192.168.1.4 255.255.255.0
#
return
# Display the valid configuration information of all user interfaces.
<Sysname> system-view
#
user-interface con 0
user-interface aux 0
authentication-mode none
user privilege level 3
user-interface vty 0 4
authentication-mode none
user privilege level 3
#
return
reset saved-configuration
Syntax
reset saved-configuration