R3204P16-HP Load Balancing Module System Management Command Reference-6PW101

30
Description
Use the telnet server enable command to enable the Telnet server.
Use the undo telnet server enable command to disable the Telnet server.
The Telnet server is disabled by default.
Examples
# Enable the Telnet server.
<Sysname> system-view
[Sysname] telnet server enable
terminal type
Syntax
terminal type { ansi | vt100 }
undo terminal type
View
User interface view
Default level
2: System level
Parameters
ansi: Specifies the terminal display type as ANSI.
vt100: Specifies the terminal display type as VT100.
Description
Use the terminal type command to configure the type of terminal display of the current user interface.
Use the undo terminal type command to restore the default.
By default, the terminal display type is ANSI.
The device supports two types of terminal display: ANSI and VT100. HP recommends you to set the
display type of both the device and the client to VT100. If the device and the client use different display
types (for example, hyper terminal or Telnet terminal) or both are set to ANSI, when the total number of
characters of the currently edited command line exceeds 80, an anomaly such as cursor corruption or
abnormal display of the terminal display may occur on the client.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] terminal type vt100
user privilege level
Syntax
user privilege level level
undo user privilege level