R3204P16-HP Load Balancing Module System Management Command Reference-6PW101

32
last-num1: Absolute number of the last user interface, which ranges from 1 to 54 but cannot be smaller
than the first-num1.
aux: Specifies the AUX user interface.
console: Specifies the console user interface.
vty: Specifies the VTY user interface.
first-num2: Relative number of the first user interface. It is 0 for both AUX and console user interfaces, and
ranges from 0 to 4 for the VTY user interface.
last-num2: Relative number of the last user interface. It ranges from 1 to 4, but cannot be smaller than
first-num 2 for the VTY user interface. This argument is not supported on other user interfaces.
Description
Use the user-interface command to enter a single or multiple user interface views.
In a single user interface view, the configuration takes effect in the user view only.
In multiple user interface views, the configuration takes effect in these user views.
Examples
# Enter the console user interface view.
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0]
# Enter the user interface views of VTYs 0 to 4.
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4]
OAP module configuration commands
oap connect
Syntax
oap connect slot slot-number
View
User view
Default level
1: Monitor level
Parameters
slot slot-number: Specifies the number of the slot where an OAP system resides.
Description
Use the oap connect command to redirect from the device to the OAP module.
To return from the operating system on the OAP module to the CLI on the device, press Ctrl+K.
Examples
# Redirect from the device to the OAP module in slot 3.