R3204P16-HP Load Balancing Module System Management Command Reference-6PW101

87
undo ntp-service broadcast-client
View
Interface view
Default level
3: Manage level
Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the NTP broadcast
client mode and use the current interface to receive NTP broadcast packets.
Use the undo ntp-service broadcast-client command to remove the configuration.
By default, the device does not work in the NTP broadcast client mode.
Examples
# Configure the device to work in broadcast client mode and receive NTP broadcast messages on
Ten-GigabitEthernet 0/0.1.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet0/0.1
[Sysname-Ten-GigabitEthernet0/0.1] ntp-service broadcast-client
ntp-service broadcast-server
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default level
3: Manage level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to broadcast
clients, where keyid ranges from 1 to 4294967295. This parameter is not meaningful if authentication is
not required.
version number: Specifies the NTP version, where number ranges from 1 to 3 and defaults to 3.
Description
Use the ntp-service broadcast-server command to configure the device to work in the NTP broadcast
server mode and use the current interface to send NTP broadcast packets.
Use the undo ntp-service broadcast-server command to remove the configuration.
By default, the device does not work in NTP broadcast server mode.