R3204P16-HP Load Balancing Module System Management Command Reference-6PW101

88
Examples
# Configure the device to work in broadcast server mode and send NTP broadcast messages on
Ten-GigabitEthernet 0/0.1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet0/0.1
[Sysname-Ten-GigabitEthernet0/0.1] ntp-service broadcast-server authentication-keyid 4
version 3
ntp-service in-interface disable
Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
Interface view
Default level
3: Manage level
Parameters
None
Description
Use the ntp-service in-interface disable command to disable an interface from receiving NTP messages.
Use the undo ntp-service in-interface disable command to restore the default.
By default, all interfaces are enabled to receive NTP messages.
Examples
# Disable interface Ten-GigabitEthernet 0/0.1 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet0/0.1
[Sysname-Ten-GigabitEthernet0/0.1] ntp-service in-interface disable
ntp-service max-dynamic-sessions
Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
View
System view
Default level
3: Manage level
Parameters
number: Maximum number of dynamic NTP sessions that are allowed to be established, which ranges
from 0 to 100.