R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

You can log in to a device in the following ways.

Table 1 Login methods

in method Default state

CLI login

Logging in

through the

console p

ort

By default, you can log in to a device through the console port, the

authentication mode is None (no username or password required), and the user

privilege level is 3.

Logging in

through Telnet

By default, you cannot log in to a device through Telnet. To do so, log in to the

device through the console port, and complete the following configuration:

• Enable the Telnet function.

• Configure the IP address of the management Ethernet interface

GigabitEthernet 0/1, and make sure that your device and the Telnet client

can reach each other (by default, the IP address of the management Ethernet

interface is 192.168.0.1/24).

• Configure the authentication mode of VTY login users (scheme default).

• Configure the user privilege level of VTY login users (0 by default).

Web login

By default, you can log in to a device through web. If the web function is

disabled, you need to log in to the device through the console port, and

complete the following configuration:

• Configure the IP address of the management Ethernet interface

GigabitEthernet 0/1, and make sure the device and web terminal can reach

each other (by default, the IP address of the management Ethernet interface

GigabitEthernet 0/1 is 192.168.0.1/24.).

• Configure a username and password for web login (by default, the username

and password are admin ).

• Configure the user privilege level for web login (by default, the user privilege

level is 3).

• Configure the web service type for web login (not configured by default).

NMS login

By default, you cannot log in to a device through a network management station

(NMS). To do so, log in to the device through the console port, and complete the

following configuration:

• Configure the IP address of the management Ethernet interface

GigabitEthernet 0/1, and make sure the device and the NMS can reach

each other (by default, the IP address of the management Ethernet is

192.168.0.1/24. ).

• Configure SNMP basic parameters.