R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

14
Authentication
mode
Configuration Remarks
Scheme
Configure the authentication scheme
For more information, see
“Configuring scheme
authentication for console
login.”
Select an
authentic
ation
scheme
Remote AAA
authentication
Configure a RADIUS
scheme
Configure the AAA scheme
used by the domain
Configure the username
and password on the AAA
server
Local
authentication
Configure the
authentication username
and password
Configure the AAA scheme
used by the domain as local
NOTE:
A
newly confi
g
ured authentication mode does not take effect unless you exit and enter the CLI again.
Configuring none authentication for console login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see “Configuration requirements.”
Configuration procedure
Follow these steps to configure none authentication for console login:
To do… Use the command…
Remarks
Enter system view system-view —
Enter console user
interface view
user-interface console number —
Specify the none
authentication mode
authentication-mode none
Required
By default, you can log in to the device
through the console port without
authentication, and have user privilege level
3 after login.
Configure common
settings for console login
—
Optional
See “Configuring common settings for
console login (optional).”
After the configuration, the next time you log in to the device through the console port, you are prompted
to press enter. A prompt such as <HP> appears after you press Enter, as shown in Figure 10.